Home Comfort Solutions in Scottsdale, AZ

The Problem

A homeowner contacted Desert Attic Solutions for an insulation removal job after experiencing a water leak and mold issues in the attic. The project focused on clearing out the existing fiberglass insulation and exposing the area underneath for the next stage of work.\

The Inspection

Before the removal, fiberglass insulation covered sections of the attic floor, with thick, uneven piles around the wooden framing and beneath the ductwork. This material concealed the underlying surfaces and made access to those areas more difficult.

With the homeowner’s water leak and mold concerns in mind, removing the existing insulation was the focus of our work.

The Solution

Our Desert Attic Solutions team removed the fiberglass insulation from the work area, clearing material from between the framing and beneath the ductwork.

As the insulation was removed, the previously covered surfaces became exposed. The after photo shows the cleared space, with the wooden framing and ceiling surfaces below now visible.

This removal work opened up the area and provided access for any additional assessment or follow-up work needed.

The Outcome

The attic went from an area filled with uneven piles of fiberglass insulation to a cleared space with the underlying surfaces exposed.

For the homeowner, completing the insulation removal was a practical step forward after dealing with water leak and mold issues. With the old insulation cleared from the work area, the space is now accessible for the next phase of the project.

The Challenge
Kathie F.’s attic had very little existing cellulose insulation, along with fiberglass batts that needed to be removed. The evaluation also identified bathroom exhaust ventilation needs, a long rectangular duct that could benefit from additional insulation, and a large opening near the water heater that needed to be covered before adding cellulose. A small attic hatch presented an additional access challenge.

The Recommended Solution
Desert Attic Solutions recommended removing the fiberglass batts and installing 12 inches of blown-in cellulose over the existing insulation. The proposed work also included spray foam encapsulation of approximately 40 feet of rectangular ductwork.

For the two bathroom exhaust fans, the plan was to add ducting and, if space allowed, route both vents outdoors through the gable. A cover would also be installed over the opening near the water heater to prevent cellulose from falling into it. The recessed light’s insulation-contact rating would be checked to determine whether a protective cover was needed.

The Goal
These improvements are designed to strengthen the attic’s insulation coverage, reduce heat transfer through the ductwork, and improve bathroom exhaust ventilation—helping Kathie enjoy a more comfortable home.

Improving Home Comfort with Rooftop Duct Insulation for Stephanie S.

The Challenge
Stephanie S.’s rooftop ductwork needed improved insulation and sealing to help protect cooled air from Arizona’s heat, with particular attention to the duct leading into her daughter’s room.

Our Solution
Our team applied spray foam insulation to the rooftop ductwork, followed by three layers of paint over the foam. We also applied mastic sealant around the entire duct leading into Stephanie’s daughter’s room to help reduce air leakage.

The Result
The ductwork is now insulated and sealed to help limit heat gain and air leakage, supporting more efficient delivery of cooled air and better comfort throughout the home.